Cadillac Escalade Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-9159314) - 2016 - crc - 6/25/15228 Driving and Operating+RES (Resume/Accelerate) : Ifthere is a set speed in memory,press the control up briefly toresume that speed or press andhold to accelerate. If the cruisecontrol is already active, use toincrease vehicle speed.SET− (Set/Coast) : Press thecontrol down briefly to set the speedand activate cruise control. If thecruise control is already active, useto decrease vehicle speed.* (Cancel) : Press to disengagecruise control without erasing theset speed from memory.Setting Cruise ControlIf J is on when not in use, SET− or+RES could get pressed and go intocruise when not desired. Keep Joff when cruise is not being used.To set cruise control:1. Press J.2. Get up to the desired speed.3. Press and release SET− .4. Remove foot from theaccelerator.When the cruise control has beenset to the desired speed, a greencruise control indicator appears onthe instrument cluster and a cruiseset speed message appears on theDriver Information Center (DIC) andHead-Up Display (HUD),if equipped.Resuming a Set SpeedIf the cruise control is set at adesired speed and then the brakesare applied or * is pressed, thecruise control is disengaged withouterasing the set speed from memory.Once the vehicle speed reachesabout 40 km/h (25 mph) or more,press +RES up briefly. The vehiclereturns to the previous set speed.Increasing Speed While CruiseControl is at a Set SpeedIf the cruise control system isalready activated:. Press and hold +RES up untilthe vehicle accelerates to thedesired speed, then release it.. To increase vehicle speed insmall increments, press +RESup briefly. For each press, thevehicle goes about 1.6 km/h(1 mph) faster.The speedometer reading can bedisplayed in either English or metricunits. See Instrument Cluster 0 125.The increment value used dependson the units displayed.Reducing Speed While CruiseControl is at a Set SpeedIf the cruise control system isalready activated:. Press and hold SET− down untilthe desired lower speed isreached, then release it.. To decrease the vehicle speed insmall increments, press SET−down briefly. For each press, thevehicle goes about 1.6 km/h(1 mph) slower.The speedometer reading can bedisplayed in either English or metricunits. See Instrument Cluster 0 125.The increment value used dependson the units displayed.
