REMOTE DOOR UNLOCKThis feature allows you to select the type of feedbackyou will receive when unlocking the vehicle withthe Remote Keyless Entry (RKE) transmitter. You willnot receive feedback when unlocking the vehiclewith the RKE transmitter if the doors are open. SeeRemote Keyless Entry (RKE) System Operationon page 2-4 for more information.Press the customization button until REMOTE DOORUNLOCK appears on the DIC display. Press theset/reset button once to access the settings for thisfeature. Then press the customization button to scrollthrough the following settings:LIGHTS OFF: The exterior lamps will not flash whenyou press the unlock button on the RKE transmitter.LIGHTS ON (default): The exterior lamps willflash when you press the unlock button on the RKEtransmitter.NO CHANGE: No change will be made to this feature.The current setting will remain.To select a setting, press the set/reset button while thedesired setting is displayed on the DIC.DELAY DOOR LOCKThis feature allows you to select whether or not thelocking of the vehicle’s doors and liftgate will be delayed.When locking the doors and liftgate with the powerdoor lock switch and a door or the liftgate is open, thisfeature will delay locking the doors and liftgate untilfive seconds after the last door is closed. You will hearthree chimes to signal that the delayed lockingfeature is in use. The key must be out of the ignition forthis feature to work. You can temporarily overridedelayed locking by pressing the power door lock switchtwice or the lock button on the RKE transmitter twice.See Delayed Locking on page 2-11 for more information.Press the customization button until DELAY DOORLOCK appears on the DIC display. Press the set/resetbutton once to access the settings for this feature.Then press the customization button to scroll throughthe following settings:OFF: There will be no delayed locking of thevehicle’s doors.ON (default): The doors will not lock until five secondsafter the last door or the liftgate is closed.NO CHANGE: No change will be made to this feature.The current setting will remain.To select a setting, press the set/reset button while thedesired setting is displayed on the DIC.3-64
