Bosch Integrus Installation And Operation Manual

Also see for INTEGRUS: Operation manual Installation and operating manual Installation and operating manual Installation and user instructions Installation and operating manual

70 en | Operation IntegrusIOM-INT | V1.1 | 2010.12 Installation and Operation manual Bosch Security Systems B.V.The 'Source/volume' screen also displays level meters (two for a stereo source, one for amono source) for a visual indication of the actual signal strength: = low level, = high level,= overflow.9.1.5 View version informationIn the Enquiry sub-menu (3), version information of the transmitter can be found. Thisinformation should be mentioned in service requests or failure reports.9.2 Integrus radiatorsA radiator consists of two IRED panels. Each IRED panel has an amber and a red indicator LEDwhich show the status of the radiator panel9.3 Integrus Receivers9.3.1 Normal operationThe receiver cannot operate when no headphone is connected. After connecting theheadphone the receiver switches to stand-by mode. Push shortly on the on/off button toswitch the receiver on.Aux.R Volume:-31 ... 0 dBThe signal on the Aux. Right input isavailable on the monitoring headphoneoutput.- None Volume:-31 ... 0 dBThe monitoring headphone output isswitched off during normal operation,but is active when the sensitivity of oneof the inputs is being changed.Menu Item Option Value 1 Value 2 DescriptionMenu Item Value (read only) Description3A Serial Number e.g. 19.0.00001 Shows the serial number of the transmitterboard.3B HW Version e.g. 01.00 Shows the version number of the transmitterboard.3C FPGA Version e.g. 2.00.00 Shows the version number of the FPGAsoftware of the transmitter board.3D FW Version e.g. 1.00.0001 Shows the version number of the transmitterfirmware.Red LED Amber LED Statuson off Stand-by modeoff on Transmittingflashing on At switch-on:Initializing signal equalisationDuring operation:Temperatureprotection mode. See section 11.1 .on on IRED panel failure. See section 11.1 .NOTICE!The indicator LEDs are positioned behind the semi-transparent cover and are only visiblewhen ON.