Bosch BAT 690 Original Instructions Manual

Also see for BAT 690: Important Informations Repair instructions

1 689 989 234 2018-06-08| Robert Bosch GmbH22 | BAT 690 | Configurationen6.2 LanguageThe "Language" menu is used to set the BAT 690program language.i After switching the device on or after resetting it tofactory settings, the "Language settings" menu isdisplayed automatically.1. Select the "Language" menu item.2. Press . The "Language" menu is displayed.3. Select the language with or .4. Press . The language is selected and the "Configuration"menu is displayed.6.3 ContrastThe "Contrast" menu is used to set the contrast of theTFT display.1. Select the "Contrast" menu item.2. Press . The "Contrast" menu is displayed.3. Set the contrast with or .4. Press . The contrast is set and the "Configuration" menuis displayed.6.4 Self-testThe BAT 690 is checked in the "Self-test" menu. To dothis, a functional battery must be connected via thecharging cables.1. Select the "Self-test" menu item.2. Connect charging cables to the battery.3. Press . The "Self-test" menu is displayed.4. Press . Self-test is performed. The result of the self-test is displayed, e.g.self-test successfulno errors.5. Press . The "self-test" is complete and the "Configura-tion" menu is displayed.6.5 Software versionThe "Software version" menu displays the currentsoftware version of the BAT 690.1. Select the "Software version" menu item.2. Press . The software version is displayed.3. Press . The "Configuration" menu is displayed.6.6 Factory settingThe customer-specific parameters are deleted andreplaced by the factory parameters in the "Factorysetting" menu.1. Select the "Factory setting" menu item.2. Press .3. Press . The factory parameters are applied and the "Con-figuration" menu is displayed.6.7 Software updateSoftware updates for BAT 690 are available onthe Automotive Service Solutions Website atwww.downloads.bosch-automotive.com. The software updatecan be downloaded to PC/laptop from the website.To install the software update on the BAT 690, theBAT 690 must be connected to the PC/laptop via a USBconnecting cable.6.8 Instructions in case of faultsFault Action to be takenBAT 690 not workingafter being switchedon, red LED does notlight up.Disconnect mains plug and check thepower supply and power supply cable.Red LED flashes afterthe battery has beendisconnected.Check the polarity at the battery: redcharging clip – positive terminal (+), blackcharging clip – negative terminal (–).Fault message Action to be takenNo battery connected No battery connected or battery voltagetoo low.Warning!OvervoltageCheck if the correct battery isconnected.Error! Call customerserviceInform customer service.Warning!Check clipsCheck the polarity at the battery: redcharging clip – positive terminal (+), blackcharging clip – negative terminal (–).Fault no. Action to be taken10 Check the polarity at the battery: red charging clip –positive terminal (+), black charging clip – negativeterminal (–).20 No battery connected or battery voltage too low.30 Battery overvoltage, check battery.200, 210,220, 230Check set charging parameters and battery.290 Switch off BAT 690 and wait 10 seconds, thenswitch back on and check charging parameters.310 Battery short circuit, check battery.320 Battery defective, check battery.360 Excessive temperature in the BAT 690, switch offBAT 690 and allow it to cool down.370 Insufficient temperature in the BAT 690, warm upBAT 690.In case of any other malfunctions or fault numbers,inform customer service.