Bosch AUTODOME IP 4000i User Manual

Also see for AUTODOME IP 5000i: Configuration

6 en | Browser connection AUTODOME IP 4000i/AUTODOME IP 5000i/AUTODOME IP 5000i IR2018.05 | 1.1 | User Manual Bosch Security Systems1 Browser connectionA computer with Microsoft Internet Explorer is used to receive live images, control the unit,and replay stored sequences. The unit is configured over the network using the browser.1.1 Systems requirementsOur recommendations are:– Computer with Intel Skylake processor or better– Intel HD530 graphic card with performance that matches or is better than the resolutionof the camera– Windows 7 or later operating system– Network access– Internet Explorer version 11 or later– or –Application software, for example, Video Security Client, Bosch Video Client or BoschVideo Management System.Note:To see live images in your browser it might be necessary to download and install the MPEG-ActiveX from the Bosch download store.1.2 Establishing the connectionThe unit must have a valid IP address to operate on your network and a compatible subnetmask.By default, DHCP is pre-set at the factory to On plus Link-Local so a DHCP server assigns anIP address or, if no DHCP server is available, a link-local address (auto-IP) is assigned withinthe range 169.254.1.0 to 169.254.254.255.You can use IP Helper or Configuration Manager to find the IP address. Download the softwarefrom http://downloadstore.boschsecurity.com.1. Start the Web browser.2. Enter the IP address of the unit as the URL.3. During initial installation, confirm any security questions that appear.If a RADIUS server is used for network access control (802.1x authentication), you mustconfigure the device before the device can communicate with the network.To configure the device, connect it directly to a computer using a network cable and then setthe service-level password.Note:If you cannot connect, the unit may have reached its maximum number of connections.Depending on the device and network configuration, each unit can have up to 50 web browserconnections, or up to 100 connections via Bosch Video Client or Bosch Video ManagementSystem.1.3 Password protection in cameraThe device is password-protected. The first time that any user accesses the device, the devicewill prompt the user to set a password at the service level.The camera requires a strong password. Follow the prompts in the dialog box, which specifieswhat is required. The system measures the strength of the password that you enter.