Bosch AUTODOME IP 4000i User Manual

Also see for AUTODOME IP 5000i: Configuration

AUTODOME IP 4000i/AUTODOME IP 5000i/AUTODOME IP 5000i IR Alarm | en 47Bosch Security Systems User Manual 2018.05 | 1.1 |8 Alarm8.1 Alarm ConnectionsYou can select how the camera responds to an alarm. In the event of an alarm, the unit canautomatically connect to a pre-defined IP address. You can enter up to ten IP addresses towhich the camera will connect in sequence in the event of an alarm, until a connection ismade.Connect on alarmSelect On so that the camera automatically connects to a predefined IP address in the eventof an alarm.By setting Follows input 1*, the unit maintains the connection that has been automaticallyestablished for as long as an alarm exists on alarm input 1.Notice!In the default setting, Stream 2 is transmitted for alarm connections. Consider this whenassigning the profile (see Encoder Profile).Number of destination IP addressSpecify the numbers of the IP addresses to be contacted in the event of an alarm. The unitcontacts the remote stations one after the other in the numbered sequence until a connectionis made.Destination IP addressFor each number, enter the corresponding IP address for the desired remote station.Destination passwordIf the remote station is password protected, enter the password here.Only ten passwords can be defined here. Define a general password if more than tenconnections are required. The unit connects to all remote stations protected by the samegeneral password. To define a general password:1. Select 10 in the Number of destination IP address list box.2. Enter 0.0.0.0 in the Destination IP address field.3. Enter the password in the Destination password field.4. Set the user password of all the remote stations to be accessed using this password.Setting destination 10 to the IP-address 0.0.0.0 overrides its function as the tenth address totry.Video transmissionIf the unit is operated behind a firewall, select TCP (HTTP port) as the transfer protocol. Foruse in a local network, select UDP.!Caution!Please note that in some circumstances, a larger bandwidth must be available on the networkfor additional video images in the event of an alarm, in case Multicast operation is notpossible. To enable Multicast operation, select the UDP option for the Video transmissionparameter here and on Network Access.StreamSelect the number of the stream from the drop-down list.