Bosch AUTODOME IP 4000i User Manual

Also see for AUTODOME IP 5000i: Configuration

16 en | General AUTODOME IP 4000i/AUTODOME IP 5000i/AUTODOME IP 5000i IR2018.05 | 1.1 | User Manual Bosch Security SystemsIf you decide to create alternative daylight saving time dates by editing the table, note thatvalues occur in linked pairs (DST start and end dates).First, check the time zone setting. If it is not correct, select the appropriate time zone andclick Set.1. Click Details to edit the DST table.2. Select the region or the city which is closest to the system's location from the list boxbelow the table.3. Click Generate to fill the table with the preset values from the unit.4. Click one of the entries in the table to make changes. The entry is highlighted.5. Click Delete to remove the entry from the table.6. Choose other values from the list boxes under the table, to change the selected entry.Changes are immediate.7. If there are empty lines at the bottom of the table, for example after deletions, add newdata by marking the row and selecting values from the list boxes.8. When finished, click OK to save and activate the table.Time server IP addressThe camera can receive the time signal from a time server using various time server protocols,and then use it to set the internal clock. The unit polls the time signal automatically once everyminute.Enter the IP address of a time server here.Time server typeSelect the protocol that is supported by the selected time server. Preferably, you shouldselect the SNTP server as the protocol. This supports a high level of accuracy and is requiredfor special applications and subsequent function extensions.Select Time server for a time server that works with the protocol RFC 868.4.4 Display StampingVarious overlays or “stamps” in the video image provide important supplementary information.These overlays can be enabled individually and are arranged on the image in a clear manner.Camera name stampingThis field sets the position of the camera name overlay. It can be displayed at the Top, at theBottom or at a position of your choice that you can then specify using the Custom option. Orit can be set to Off for no overlay information.1. Select the desired option from the list.2. If you select the Custom option, additional fields are displayed where you can specify theexact position (Position (XY)).3. In the Position (XY) fields, enter the values for the desired position.LogoTo place a logo on the image, select and upload an uncompressed .bmp file with a maximumsize of 128x128 pixels and 256 colors to the camera. Its position on the image can then beselected.Logo positionSelect the position for the logo on the OSD: To the left of the name, To the right of thename, or Logo only.Select Off (the default value) to disable logo positioning.