Bosch AUTODOME 7100i Installation Manual

Also see for AUTODOME 7100i: User manual Installation manual

AUTODOME 7100i│AUTODOME 7100i IR Connection | en 65Bosch Security Systems Installation Manual 2023-09-29 | V06 | F.01U.410.315!Warning!Make sure that you connect the outgoing power supply wires to the appropriate pins asdescribed. Power supply fuse XF103 can handle a higher amperage (3.15 A) than fuseXF102 (2.0A).6. Connect the first wire to pin 5 (24VAC Neutral) connector.7. Connect the second wire to pin 4 (24VAC Line) connector. (Note: the 3.15A fuse is inthis line.)8. Connect the third wire to pin 3 (Earth Ground) connector.9. For the AUTODOME 7100i non-IR model (NDP-7602-Z40) only, complete the three substeps that follow, and then proceed to further steps. For IR models, skip to the nextstep.a. Route the 24 VAC outgoing power supply wires through a conduit hole to electricallygrounded conduit, through a mount that supports grounded conduit (like NDA-U-WMP)to the pipe mount and to the camera, or through the Arm Mount and WPLATE to thecamera.b. Cut and trim the 24 VAC power with sufficient slack to reach their connectorterminal X105 in the camera, but not so long as to be pinched by or to obstruct closingthe cover door.c. Attach the 24VAC lines to AUTODOME 7100i User Interface connector X105, asillustrated below.Note: Use of proper grommets is necessary to guarantee an IP66 rating.Note: Refer to Tools Required, page 14 for a list of the appropriate types of Ethernetcable to use.10. Route the Ethernet cable through the points mentioned in the list that follows, insequence:a. From the User Interface connector X104 in the pipe or ARM mount (as shown below)b. Into a 3/4 in. (20mm) NPS metal conduit fitting in the NDA-U-WMP (for instance)when using a pipe mount or in the WPLATE when using the arm mount.c. Through electrically grounded, liquid tight metal conduitd. To a 3/4 in. (20mm) NPS metal conduit fitting in the PSU box, ande Out another 3/4 in. (20mm) NPS metal conduit fitting in the PSU boxf. Through electrically grounded, liquid tight metal conduit