Bosch AUTODOME 7100i Installation Manual

Also see for AUTODOME 7100i: User manual Installation manual

AUTODOME 7100i│AUTODOME 7100i IR Connection | en 49Bosch Security Systems Installation Manual 2023-09-29 | V06 | F.01U.410.31510.3 Power by 24 VAC/36 VDC10.3.1 Recommendations for 24 VAC Power SupplyBosch recommends operating the AUTODOME 7100i IR camera models (NDP‑7602‑Z40L,NDP-7604-Z12L) by IEEE 802.3bt PoE Type 4, 90W. You can also use a third-party 24 VAC,50/60Hz power supply that meets the stated requirements.A 24 VAC, 50/60Hz power supply must meet the following requirements to be used with theAUTODOME camera.The power supply must provide 24 VAC +/-10% voltage at the camera after any voltage dropacross the cable, and for the following current and power loads as in the table that follows.Model Minimum current output required(Amps)Minimum power output required(Watts)24 VAC,50/60 HzPoE 54VDC36 VDC 24 VAC,50/60 Hz(PF = 0.6)PoE 54VDC36 VDC2MP (non-IR)3 0.9 1.3 43.2 48.6 46.82MP IR, 4KIR3.5 1.2 1.85 53 64.8 66.6!Warning!The product should be supplied only by an external power supply that is a certified Class 2or Limited Power Source (LPS) supply.It must be an electrically Earth-grounded metal box with a watertight, electrically groundedmetal conduit that is connected between the box and the AUTODOME camera.Note: For the system of the AUTODOME camera and the chosen power device (third-partyIEEE 802.3bt midspan or 24 VAC) to meet all of the AUTODOME certifications andspecifications, the midspan/power supply must meet the same certifications andrequirements.