Bosch AUTODOME 7100i Installation Manual

Also see for AUTODOME 7100i: User manual Installation manual

22 en | Installing a mount power supply box (wall, mast (pole), and cornermounts) - (for non-IR NDP-7602-Z40 camera models) AUTODOME 7100i│AUTODOME 7100i IR2023-09-29 | V06 | F.01U.410.315 Installation Manual Bosch Security Systems7 Installing a mount power supply box (wall, mast(pole), and corner mounts) - (for non-IR NDP-7602-Z40 camera models)See sections Recommendations for 24VAC Power Supply and Compatible 24VAC PowerSuppliesNote: Bosch Wall, mast (pole) and corner mounts are only guaranteed to work with Boschpower supplies.Before mounting the Power Supply Box, decide if you should wire the box through the holesin the bottom or back of the box. If wiring the box through the back, move the two (2) sealplugs to the bottom through the holes before mounting.iNotice!Use ¾ inch (20 mm) NPS fittings for the holes on the bottom and back of the box. Use ½inch(15 mm) NPS fittings for the side holes.Figure 7.1: Power Supply Wall, Mast (pole), and Corner Mounts1. Use the wall mount template supplied in the packaging box to locate the four (4)mounting holes for the power supply box.2. Drill four holes for the mounting anchors. If installing outdoors, apply a weatherproofsealant around each hole at the mounting surface.!Warning!A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265lb) pull-out force is recommended. The mounting material must be able to withstand thispull out force. For example, 19 mm (3/4 inch) minimum for plywood.3. Secure the Power Supply Box to the mounting surface.– For a Wall installation: Use four (4) corrosion-resistant, stainless steel studs (notsupplied). Then proceed to Step 5 below.– For a Corner installation: Secure the Corner Plate to the wall corner using four (4)studs (not included). Then proceed to Step 5 below.