Black & Decker bdl170b Manuel

Contents

4ENGLISHIntended useThis Black & Decker tool has been designed to project laserlines to aid in DIY applications. This tool is intended forconsumer use only.Safety instructions Warning! When using battery-powered tools, basic safetyprecautions, including the following, should always befollowed to reduce the risk of fire, leaking batteries,personal injury and material damage. Read all of this manual carefully before operating the tool. Retain this manual for future reference.Keep work area cleanCluttered areas and benches can cause accidents.Consider work area environmentDo not expose the tool to rain. Do not use the tool in damp orwet conditions. Keep the work area well lit. Do not use the toolwhere there is a risk of causing fire or explosion, e.g. in thepresence of flammable liquids and gases.Keep children awayDo not allow children, visitors or animals to come near thework area or to touch the tool.Do not overreachKeep proper footing and balance at all times.Stay alertWatch what you are doing. Use common sense.Do not operate the tool when you are tired.Use appropriate toolThe intended use is described in this instruction manual.Warning! The use of any accessory or attachment orperformance of any operation with this tool other than thoserecommended in this instruction manual may present a risk ofpersonal injury.Check for damaged partsBefore use, carefully check the tool for damage. Ensure thatthe tool will operate properly and perform its intended function.Do not use the tool if any part is damaged or defective.Store idle toolsWhen not in use, tools and batteries should be stored in a dry,locked up or high place, out of reach of children.RepairsThis tool complies with relevant safety requirements.Repairs should only be carried out by qualified persons usingoriginal spare parts; otherwise this may result in considerabledanger to the user.Additional safety instructions for non-rechargeablebatteriesWarning! Batteries can explode or leak, and can cause injuryor fire. Observe the instructions as described below. Carefully follow all instructions and warnings on thebattery label and package. Always place batteries correctly according to the polarity(+ and -) as marked on the battery and the product. Do not short-circuit the battery terminals. Do not attempt to charge non-rechargeable batteries. Do not mix old and new batteries. Replace all of thebatteries at the same time with new batteries of the samebrand and type. Keep batteries out of reach of children. Remove batteries if the product will not be used forseveral months. Under extreme conditions, battery leakage may occur.When you notice liquid on the batteries, proceed as follows:- Carefully wipe the liquid off using a cloth.Avoid skin contact. Never attempt to open for any reason. Do not store in locations where the temperature mayexceed 40 °C. When disposing of batteries, follow the instructions givenin the section "Protecting the environment". Do not incinerate the batteries.Additional safety instructions for lasersRead all of this manual carefully.This product is not to be used by children under 16.Warning! Laser radiation.Do not look into the laser beam.Do not view the laser beam directly with opticalinstruments.Refer to the laser product characteristics. This laser complies with class 2 according to IEC 60825-1:Ed 1:2001. Do not replace a laser diode with a differenttype. If damaged, have the laser repaired by an authorisedrepair agent. Do not use the laser for any purpose other than projectinglaser lines. An exposure of the eye to the beam of a class 2 laser isconsidered safe for a maximum of 0.25 seconds.Eyelid reflexes will normally provide adequate protection.At distances over 1 m, the laser complies with class 1 andthus is considered completely safe.