Barco XDL-4K75 User Manual

Also see for XDL-4K30: Installation manual User manual

Barco XDL-4K75 User Manual Manual pdf 39 page image

4. Getting Started4.6 Projector AddressProjector addressAddress installed in the projector to be individually controlled.Broadcast addressProjector will always execute the command coming from a RCU programmed with that broadcast address.Why a projector address?As more than one projector can be installed in a room, each projector should be separately addressable with an RCU or computer.Therefore each projector has its own address.Set up an individual Projector AddressThe set up of a projector address can be done via the software.Projector controllingWhen the address is set, the projector can be controlled now:• with the RCU: only for addresses between 1 and 31.Broadcast AddressEvery projector has a broadcast (common) address ’0’ or ’1’. The default address is ’0’.The choice between ’0’ and ’1’ can be selected in the GUI: “System Settings” → “Communication” →“IR Control “.Placing new batteries in the remote control or plugging the remote to a projector via a cable will automaticallyreset the address back to its default value ’0’.4.7 Quick setup via Direct accessQuick source selection1. Press the Input button on the remote control or local keypad.IIImage 4-7R5906151 XDL 17/04/2018 35