3. Getting startedBarco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004 ________________________________________________________________________ 3-203.2.10 RGB Input CardThe RGB INPUT CARD provides the capability of displaying RGB monitor signals. The analog signals are digitized forfurther processing in ARGUS.The RGB Input Card is available in various versions; only RGB Input Cards with versionwith versionRGB-2774-14 or higher are supported by the OmniBus.StandardThe synchronization modes Hsync+VsyncVsync, Csync and Sync-on-Green are supported.ConnectorsThe RGB INPUT CARD has two VGA compatible 15-pin SubMinD connectors. TheSubMinD connectors. The RGB In is for connecting the RGBsignal to the OMNI BUS whereas RGB Out can be connected to an additional monitor which will receive the loopedthrough signal.RGB InRGB OutFigure 3-25RGB I NPUT C ARDOrderThe order in that the input cards are inserted into one or more OMNI BUS devices is given in the sections 3.2.15Argus OmniBus and 3.2.16 Arrangement of expansion cards.SpecificationsFor detailed technical specifications of the RGB INPUT CARD please refer to section 7.1 Technical data.
