Afag CR 25 Assembly & Operating Instructions

Contents

Afag CR 25 Assembly & Operating Instructions Manual pdf 50 page image

Maintenance and repair50 – 56 Assembly instructions EN  CR 25 / CR 32  Edition 01/2020  Rev. 4.09.3.3 Further maintenanceFurther maintenance is not required, if the ambient conditions listed below arecomplied with: Clean working area No use of splash water No abrasive or process dust and vapours Climate and temperature as specified in the technical data9.4 Spare parts and repair workAfag Automation AG offers a reliable repair service. Defective rotary modulescan be sent to Afag for warranty repair within the warranty period.Please note that Afag does not assume any warranty for rotary modules thathave not been replaced or repaired by Afag!NOTICERisk of damage to property!The operation of the rotary modules with oil-lubricated compressed air causesthe factory primary lubrication to be washed out. Therefore, it is absolutelyessential that the rotary modules continue to be operated with oil-lubricatedcompressed air in order to avoid damage to the rotary modules. Once the rotary modules have been operated with oil-lubricatedcompressed air, they may never be operated without oil-lubricatedcompressed air.CAUTIONRisk of injury when removing the rotary modules due to uncontrolledmovements of the rotary modules!When disassembling the rotary modules from a system, there is a danger ofuncontrolled movements. Disconnect the media supply (electrics, pneumatics) before removing themodules! Disassembly should only be carried out by qualified personnel! Bleed and deactivate the equipment before removing the rotary module! Before removing the rotary module, switch off the control unit and secure itagainst being switched on again!