Afag CR 25 Assembly & Operating Instructions

Contents

Afag CR 25 Assembly & Operating Instructions Manual pdf 42 page image

Installation, assembly & setting42 – 56 Assembly instructions EN  CR 25 / CR 32  Edition 01/2020  Rev. 4.06.3.3 Setting of the end positionsThe exact setting of an end position depends on the stop sleeve, the shockabsorber and the adjusted compressed air.Fig. 20 Exemplary illustrationTo set the end positions proceed as follows:1. Compressed air at P1: Flange rotates clockwise.2. Loosen the clamping screw of the of the stop sleeve (Fig. 20, 3).3. Turn the hexagon of the stop sleeve (Fig. 20, 2) until the end position iscorrectly adjusted.4. Compressed air at P2: Flange rotates counter-clockwise.5. Turn the hexagon of the stop sleeve (Fig. 20, 2) until the desired end positionis reached.6. Tighten the clamping of stop sleeves with the clamping screw (Fig. 20, 3). The end positions are set.6.3.4 Setting of the end position dampingTo adjust the end position damping proceed as follows:1. Loosen the hexagon nut (Fig. 20, 4) on the shock absorber.2. Screw in or out both shock absorbers (Fig. 20, 1) with the small hexagon:- the damping becomes harder when screwed in- the damping becomes softer when screwed out The end position damping is set.If the damping function is not yet optimal, it can also be adjusted with acompressed air throttle.P2P11324