Advantech EKI-6311GN User Manual

Advantech EKI-6311GN User Manual Manual pdf 4 page image

EKI-6311GN-User_Manual V2.1 Page ivFederal Communication Commission Interference StatementThis equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.- Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device mustaccept any interference received, including interference that may cause undesired operation.FCC Caution: Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate this equipment.FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an uncontrolledenvironment. To avoid the possibility of exceeding radio frequency exposure limits, you shallbeep a distance of at least 100cm between you and the antenna of the installed equipment.This transmitter must not be co-located or operating in conjunction with any other antenna ortransmitter.The availability of some specific channels and/or operational frequency bands arecountry dependent and are firmware programmed at the factory to match theintended destination. The firmware setting is not accessible by the end user.