EKI-6311GN-User_Manual V2.1 Page 22DHCP Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes). A DHCP relayagents is used to forward DHCP requests and replies between clients and servers when they arenot on the same physical subnet. To enable the DHCP relay agent, check the “Enable DHCPRelay” checkbox and enter the IP address of the DHCP server.In AP mode, the IEEE 802.11b/g/n Wireless Outdoor CPE must establish connectionwith another wireless device before it is set to Router mode. To access the unit inRouter mode via wired port, please type the WAN IP address to enter the web pagefor WAN is on wired port and LAN is on wireless port. Or, you can access devicethrough the wireless device connected with the CPE.In wireless client mode, users can access the CPE via its wired port, for WAN is onwireless port and LAN is on wired port when device is set to Router mode.Bridge mode and AP Repeater mode are similar to AP mode when device is set toRouter mode; WAN is on wired port and LAN is on wireless port. Thus users mustalso connect the CPE with another wireless device before it is set to Router modeand access the CPE via the connected wireless device.Time SettingsCompliant with NTP, the IEEE 802.11b/g/n Wireless Outdoor CPE is capable of keeping its time incomplete accord with the Internet time. Make configuration in “Time Settings” from “System”. To usethis feature, check “Enable NTP Client Update” in advance.Figure 28 Time SettingsCurrent TimeDisplay the present time in Yr, Mon, Day, Hr, Min and Sec.Warning: