Menu
Advanced LAN Bypass User Manual
                                                                                  | |
Contents
| 
43 Advanced LAN Bypass User ManualChapter 4 LBPCU4.1 ./lbpcuWhen LBPCU is started without any parameters, usage information will be displayed:Figure 4.1 Usage of the "lbpcu" Commandroot@localhost:~# ./lbpcuUsage: LBPCU {op}{op}: The operation you want to do.-V: Get liblbpcu version.-VP: Get protocol version between NIC and FW.-VF: Get FW version.-VB: Get FW bootloader version.-n: Get number of segment that define in config file-GA: Get current action for specific event on this segment-SA: Set current action for Event on this segment.-SW: Set WDT initial countdown value, 100ms/count.-GW: Get WDT status.-RW: Reset Watchdog counter to the preset value and start thecountdown.-RAW: Reset Watchdog counter to the preset value and start thecountdown for all segments.-StopW: Stop the WDT.-StopAW:Stop the WDT for all segments.-ST: Set toggle pin mode.-SEW: Set External watchdog mode.-SWT: Start wdt by toggle.-SAWT: Start wdt by toggle for all segments.-WT: Toggle the NIC to strobe/reset the WDT. Toggle pin WDT modeneeds to be enabled & armed.-WAT: Toggle the NIC to strobe/reset the WDT for all segments. Tog-gle pin WDT mode needs to be enabled & armed.-GLEA: Get last event and last action on this segment.-SCA: Set the action on this segment. This command will change theaction immediately and won't change the event-action relationship.-SACA: Set the action on all segments. This command will change theaction immediately and won't change the event-action relationship.-SRM: Start reset monitoring by LBPCU.-GRMS: Get reset monitoring status.-SRMT: Set reset monitoring timer value.-GRMT: Get reset monitoring timer value.-ML: Set message output level-SBCT: Set bypass control type-GBCT: Get bypass control type-SBL: Set duty and period for LED indication of action bypass.-GBL: Get duty and period for LED indication of action bypass.-SDL: Set duty and period for LED indication of action disconnect.-GDL: Get duty and period for LED indication of action disconnect.-SMSM: Set the master slave mode for each segments.-GMSM: Get the mode status of segment.-SML: Set the duty and the period of master LED in bypass or dis-connect.-GML: Get the duty and the period of master LED in bypass or dis-connect.-CUI: [Upgrade] Check upgrade image-UG: [Upgrade] Upgrade FW-CBTEST:evnet change callback test-GFM: [Upgrade] Get FW mode |
Related manuals for Advanced LAN Bypass
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved