Advanced LAN Bypass User Manual 8Example 2: Connects the LAN ports to the host system ONLY when application SW is run-ning and strobing the WDT Bypasses the NICs if the power is down or application SW hangs Disconnects the LAN ports from the NICs in other states (system is booting,application is not yet loaded) Master/slave mode is disabledExample 3: Connects the LAN ports to the host system only when application SW is runningand strobing the WDT Does not allow any traffic through the unit or bypassing the unit in any other sit-uation Master/Slave mode is disabledTable 2.2: Mapping between Events and Actions (Example 2)Event CONNECT DISCONNECT BYPASS DO_NOT_ CHANGEPower Up XPower Down XPower Reset XWDT Start XWDT Timeout XExternal Trigger XButton Event 1 XButton Event 2 XTable 2.3: Mapping between Events and Actions (Example 3)Event CONNECT DISCONNECT BYPASS DO_NOT_ CHANGEPower Up XPower Down XPower Reset XWDT Start XWDT Timeout XExternal Trigger XButton Event 1 XButton Event 2 XActionAction
