viAAA-130U2 Series Installation and Hardware Guide4 Installing the Software Driver for Windows NTInstalling the Array1000U2 Driver for Windows NT 4-2Installing the Driver When Installing Windows NT 4-2Installing the Driver When Windows NT is AlreadyInstalled 4-4Windows NT Installation and Configuration Notes 4-55 Installing the Software Driver for Novell NetWareInstalling the Array1000U2 Driver for Novell NetWare 5-2Installing the Driver When Installing NetWare 5-2Installing the Driver When NetWare is AlreadyInstalled 5-7Netware Installation and Configuration Notes 5-86 Installing the Software Driver for SCO UnixWareInstalling the Array1000U2 Driver for UnixWare 6-2Installing the Driver When Installing SCOUnixWare 6-2Installing the Driver When SCO UnixWare is AlreadyInstalled 6-3A Using SCSISelect and Disk UtilitiesSCSISelect Default Settings A-2Starting the SCSISelect Utility A-3Using SCSISelect Menus A-3Exiting SCSISelect A-3Using the SCSI Disk Utilities A-4SCSISelect Settings A-5SCSI Bus Interface Definitions A-5SCSI Device Configuration A-5Additional Options A-6B TroubleshootingTroubleshooting Checklist B-1Windows NT Troubleshooting B-2Error Messages While Setting Up Windows NT B-2
