Setup 4-74.4 Advanced System ConfigurationThe Advanced System Configuration section has a three-page screendisplay. The first two pages of this section are accessible with m as well asthe no-reboot Setup button ( ). The third page is accessible only with theno-reboot Setup button. The following is page 1.Advanced System ConfigurationPgDn/PgUp = Move Screen, F1 = Help, Esc = ExitPage 1/3Power Management Mode ---------------------- [Enabled]Display Standby Timer ------------------- [ 1] Minute(s)Battery-low Warning Beep ------------------- [Enabled]Suspend upon Battery-low ------------------- [Enabled]Password Check during Resume --------------- [Disabled]→ ←↑ ↓ = Move Hightlight Bar, = Change SettingHard Disk Standby Timer ----------------- [ 1] Minute(s)System Standby/Suspend Timer ------------ [ 3] Minute(s)4.4.1 Power Management ModeWith this parameter set to [Enabled], all the timers in Setup take effectunless specifically disabled by the user. Select [Disabled] to turn off allthe timers.If APM is installed under DOS or Windows, you cannot disablethe Power Management Mode under Setup. To disable APM,type Power Off under DOS, or disable the Power icon in theWindows Control Panel.
