46 PRODUCT USER GUIDE2. Choose the option Video Settings from the Options Menu of the RemoteConsole. Press the button Reset this Mode.Figure 43 Remote Console Video Settings: Reset this Mode3. Again, press the Auto Adjust button once.4. The ARMC/3P detects the video mode with 8 bits (256 colors) automatically.To improve the picture quality you may select 16 bit (True Color) from theOptions Menu of the Remote Console, sub menu “Encoding”, entry “ColorDepth” (see the Section Encoding for details).5. Finally, if the the Remote Console transfer rate is too high you may do anadjustment using the Noise filter. The higher the filter level the moreinformation is filtered from the transferred video picture (see the Sectioncalled Video in Chapter 6 for details) and the data rate is reduced.Currently, the video picture with the best quality can be achieved with the settings“16 bit (High Color)” in the Remote Console or “LAN (High Color)” in the webfrontend. This option can also be preset in Chapter 5: User Console. The submenu “Compression” from the Options menu has no influence on the picturequality but on the data rate of the picture that is transferred to the Remote Console.Reducing the Noise of the Video PictureTo reduce the noise from the video picture for the Remote Console you may adjustthe Noise filter. Prior to that we recommend optimizing the video picture asdescribed in the Section called Optimizing the Video Picture.In most cases the rate of transferred data indicates the noise level. The higher thetransfer rate, the higher the noise of the video picture. You may do an adjustmentusing the Noise filter. The higher the filter level the more information is filtered fromthe transferred video picture (see Chapter 5: Video details) and the data rate isreduced.