A&D HW-10KGL Instruction Manual

Also see for HV-15KGL: Instruction manual

Contents

A&D HW-10KGL Instruction Manual Manual pdf 58 page image

Page 56 HV-G/HW-G Series16. RS-232C Serial Interface16. RS-232C Serial InterfaceNote When the RS-232C serial interface is used, be sure to set the “Address ( f11 ) “ to“( 00 )”.RS-232C interface has the following two modes.Stream mode Outputs data continuously and can be used to print data.Command mode Controls the scale using commands from a computer.To use RS-232C interface, set the parameters of the “Baud rate ( f4 )”, “ Outputmode ( f5 )”, “ Format ( f15 )” in the function table.Optional cables are available as follows:AX-KO577A-200 RS-232C cable, D-sub 25 pin, 2 mAX-KO1786-200 RS-232C cable, D-sub 9 pin, 2 mTransmission system EIA RS-232CTransmission Asynchronous, bi-directional, half-duplexData format Baud rate 2400, 4800, 9600 bpsData 7 bitsParity 1 bit, EvenStart bit 1 bitStop bit 1 bitCode ASCIITerminator CR LF (CR: 0Dh, LF: 0Ah)Pin connectionsPin No. Signal name Direction Description A1 - A2 RXD Input Receive data A3 TXD Output Transmit data A4 - A5 SG - Signal ground A6 - A7 DSR Output Data set ready A8 - -CircuitsAdaptable connector DIN 8 pin (TCP0586)