A&D HW-10KGL Instruction Manual

Also see for HV-15KGL: Instruction manual

Contents

A&D HW-10KGL Instruction Manual Manual pdf 12 page image

Page 10 HV-G/HW-G Series5. Installing the Scale5. Installing the Scale5.1. Setting up the ScaleThe setup procedure depends on the scale model. Refer to the table below.Models Refer toHV-15KGL/HV-15KGV/HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-10KGLHW-10KGV/HW-60KGL/HW-60KGV/HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGVProcedure AHW-300KGL4/HW-300KGV4/ HW-600KGL4/HW-600KGV4 Procedure BHW-600KGL3/HW-600KGV3/ HW-1200KGL3/HW-1200KGV3 Procedure C5.1.1. Procedure AHV-15KGL/HV-15KGV/HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-10KGLHW-10KGV/HW-60KGL/HW-60KGV/HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGVThis procedure includes all of the steps for installingthe scales described above. Therefore, there maybe some unnecessary steps for some models.Step 1 Take the base unit and pole out, taking carenot to pull on the load cell cable.Step 2 Place the pan on the base unit.Step 3 Attach the pole to the bracket of the baseunit, while using care not to damage the loadcell cable.Insert the remainder of the load cell cableinto the pole.Affix the pole to the bracket using two Allenscrews.Step 4 Select a place for installing the scale. Referto "4.1. Installing the Scale” .Step 5 Adjust the level of the base unit using thebubble spirit level and the leveling feet.Step 6 Press the caps at the pole top from bothsides and adjust the angle of the display unit.Step 7 Check the weighing accuracy. If the scaleneeds calibration, refer to "14. Calibration".