AGA AIMS EC3 Installation Instructions Manual

Also see for AIMS EC3: Owner's manual Users instructions & cooking guide Users instructions & cooking guide Users instructions & cooking guide Owner's manual

Contents

AGA AIMS EC3 Installation Instructions Manual Manual pdf 6 page image

WARNING: THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING PLATE,WHICH IS SITUATED BEHIND THE UPPER LEFT HAND DOOR.A 13 amp 230v ~ 50 Hz fused electrical supply is required adjacent to the appliance. Externalwiring to the unit must be installed using a 3 core silicon - SIHF insulation cable, and inaccordance with the current wiring regulations and any local regulations which apply.The method of connection to the mains electricity supply must facilitate complete electricalisolation of the appliance, preferably by a fused double pole switch, having a contact separationof at least 3mm in both poles.A 13A safety plug can be used, however, we do strongly recommend connection via a fuseddouble pole switch for integrity of the connection. If a 13A safety plug is used it must be of a highquality and must be to BS1363 - 3: 1995 (13A Plugs, socket, outlets and adaptors).NOTE: Switched spur outlet should only serve the appliance.The isolator should not be positioned immediately above the cooker, but must be fitted within 1.5metres of the cable exit point of the appliance.ELECTRICAL6Final Electrical Test using (CLARE) and Flash TestFlash Test Procedure(Earth Appliance Test Simulation)1. Select 1250v Flash Test on Clare Test equipment.2. Plug the 13 amp supply plug into the test equipment.3. Depress the red ‘Test Button’ for 3 seconds.4. A ‘Pass’ light will illuminate.5. If the appliance fails the test, re-check all circuits and correct the fault and re-test theappliance.6. Disconnect from the test equipment and connect cooker to its permanent supply.7. A full load test will be performed using a clamp meter connected to the incoming supply.NOTE: The test results 10.5/11 amps normal operation.8. Make notes of results and disconnect all leads.A metal plate which is provided in the Aga pack MUST be positioned on the top runners of theBaking Oven. Slide the plate in fully, until it makes contact with the back of the oven.This baffle is a permanent part of the Baking Oven, to regulate the oven temperature.ELECTRICAL TEST PROCEDUREBAKING OVEN BAFFLE PLATE