With specific exceptions, the installing of any type of AgaCooker is subject to the respective directions contained incurrent issue of The Building Regulations. In addition,Planning Permission may need to be obtained, whichshould be applied for separately.The complete range of Aga cookers are suitable forNatural or Propane gases only and cannot be used onany other gas.The complete cooker is floor-mounted and the space inwhich the appliance is to be fitted must have the followingmaximum distances:-A minimum clearance of 60mm is required above theraised insulating cover handle.Side clearances are zero unless 2 or 4 oven cookers arefitted against a wall, where 116mm clearance is requiredat the right hand side for oven doors access (a further116mm is required).In addition, a minimum clearance of 1000mm must beavailable at the front of the cooker to enable the cooker tobe serviced.NOTE: AGA GAS FIRED COOKERS ARE DELIVEREDEX-WORKS UNASSEMBLED, ASSEMBLY ISUNDERTAKEN ON SITE BY THE AUTHORISED AGADISTRIBUTOR.Cooker Base or HearthIt is essential that the base or hearth on which the cookerstands should be level and be capable of supporting thetotal weight of the respective cooker,Models GC and GCB 406Kg, GE - 584Kg.The top of the hearth must be of non-combustible materialthickness of 12mm.The wall behind the cooker must be of non-combustiblematerial for a minimum thickness of 25mm.TilingWhen the cooker is to stand in a recess, or against a wallwhich is to be tiled, in no circumstances should the tilesoverlap the cooker top plate.Installation RequirementsThe installation of the cooker must be in accordance withthe relevant requirements of the Gas Regulations andBuilding Regulations in force and the bylaws of the localWater Authority.It should be in accordance also with any relevantrequirements of the Gas Region and Local Authority.In your own interest, and that of safety to comply with thelaw, all gas appliances should be installed by a competentperson, in accordance with the relative regulations.Failure to install appliances correctly could lead toprosecution.On completion, test the gas installation for soundness.REMEMBER, when replacing a part on this appliance,use only spare parts that you can be assured conform tothe safety and performance specification that we require..Do not use reconditioned or copy parts that have not beenclearly authorised by AGA.Installation Instructions forAga PF Gas Fired Cooker ModelsGC, GCB and GEConsumer ProtectionAs responsible manufacturers we take care to make sure that ourproducts are designed and constructed to meet the required safetystandard when properly installed and used.IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYINGWARRANTY. Any alteration that is not approved by Aga couldinvalidate the approval of the appliance, operation of the warrantyand could affect your statutory rights.ImportantThis appliance may contain some of the materials that are indicated.It is the Users/Installers responsibility to ensure that the necessarypersonal protective clothing is worn when handling, whereapplicable, the pertinent parts that contain any of the listed materialsthat could be interpreted as being injurious to health and safety, seebelow for information.Firebricks, Fuel beds, Artificial Fuels - when handling usedisposable gloves.Fire Cement - when handling use disposable gloves.Glues and Sealants - exercise caution - if these are still in liquid formuse face mask and disposable gloves.Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre,Kerosene Oil - may be harmful if inhaled, may be irritating to skin,eyes, nose and throat. When handling avoid inhaling and contactwith skin or eyes. Use disposable gloves, face-masks and eyeprotection. After handling wash hands and other exposed parts.When disposing of the product, reduce dust with water spray ensurethat parts are securely wrapped.FOR USE IN GB & IEGas Fired CookersPLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING YOUR AGA1 10/05 EINS 511112INSTALLATION