TROUBLESHOOTINGThe appliance does not start or it stopsduring operation.First try to find a solution to the prob-lem (refer to the table). If not, contactthe Service.With some problems, the displayshows an alarm code:• - The appliance does not fill withwater.• - The appliance does not drainthe water.• - The anti-flood device is on.WARNING!Deactivate the appliance beforeyou make the checks.Problem Possible cause Possible solutionThe programmedoes not start.The mains plug is not con-nected in the mains socket.Connect the mains plug.The appliance door is open. Close the appliance door.You did not press Start. Press Start.The fuse in the fuse box isdamaged.Replace the fuse.The delay start is set. Cancel the delay start orwait for the end of thecountdown.The appliance doesnot fill with water.The water tap is closed. Open the water tap.The water pressure is toolow.Contact your local water au-thority.The water tap is clogged orthere is limescale on it.Clean the water tap.The filter in the water inlethose is clogged.Clean the filter.The water inlet hose has akink or a bend.Make sure that the positionof the hose is correct.The anti-flood device is on.There are water leakages inthe appliance.Close the water tap andcontact the Service.The appliance doesnot drain the water.The sink spigot is clogged. Clean the sink spigot.The water drain hose has akink or a bend.Make sure that the positionof the hose is correct.After the checks are completed, acti-vate the appliance. The programmecontinues from the point of interrup-tion.If the problem occurs again, contact theService.If the display shows other alarm codes,contact the Service.ENGLISH 37