ADEMCO VISTA-40 User Manual

Also see for Ademco VISTA-40: Installation instructions User guide Installation supplement Programming guide

ADEMCO VISTA-40 User Manual Manual pdf 33 page image

– 33 –USING #70 RELAY MENU MODEGeneral InformationAsk your installer if thisfeature is active in yoursystem.Your system may be set up so that certain lights or other devices can be turned on or off byusing the #70 command from either an Alpha keypad or a telephone keypad (if voicemodule is used).To activate relays from an Alpha keypad, enter 4-digit security code + [#] +70. Followthe keypad prompts described below.To activate relays using a telephone and voice module, first dial the 2-digit phoneaccess code. When the system acknowledges the access, enter 4-digit security code + [#]+ 70. The following prompts/voice responses will begin.E N T E R D E V I C E N O .0 0 = Q U I T 0 1Voice: "ENTER DEVICE CODE NOW"Enter the 2-digit number of the device to be activated.Note that if an invalid number is entered, the system will simplyask you to reenter the number.N N D E V I C E I S O F FH I T 0 = O F F , 1 = O NVoice: "voice descriptor DEVICE nn ON/OFF. FORvoicedescriptor ON, ENTER 1, FORvoice descriptor OFF, ENTER 0"Press 0 or 1 to turn the device off or on respectively. "nn"represents the 2-digit device number andvoice descriptor isthe relay voice descriptor programmed by the installer.N N D E V I C E I S O F FH I T T H E Q K E YVoice: "voice descriptor DEVICE nn ON/OFF. TO EXIT ENTER00 NOW"From a keypad, press Q to continue. The “Enter Device No.” prompt will appear.From a telephone keypad, enter “00” to exit, or enter the next relay number to beprogrammed. The current on/off state of that relay will be annunciated as described above.Alternatively, if 6 seconds elapses with no key depression, the voice module will annunciatethe "Enter Device Code Now" message.