ADEMCO VISTA-40 User Manual

Also see for Ademco VISTA-40: Installation instructions User guide Installation supplement Programming guide

ADEMCO VISTA-40 User Manual Manual pdf 12 page image

– 12 –ENTRY/EXIT DELAYSGeneral Information Your system has preset time delays, known as exit delay and entry delay. Whenever you armyour system, exit delay gives you time to leave through the designated exit door withoutsetting off an alarm. Exit delay begins immediately after entering any arming command, andapplies to all modes of arming protection. If programmed, a slow beeping will soundthroughout the exit delay period.Entry Delay gives you time to disarm the system when you reenter through the designatedentrance door. But the system must be disarmed before the entry delay period ends, or analarm will occur. The keypad will beep during the entry delay period, reminding you to disarmthe system. You can also arm the system with no entry delay at all by using either INSTANT orMAXIMUM arming modes. These modes provide greater security while on the premises orwhile away for extended periods of time. See your installer for your delay times.Partition 1Exit Delay 1: seconds Entry Delay 1: secondsExit Delay 2: seconds Entry Delay 2: secondsPartition 2Exit Delay 1: seconds Entry Delay 1: secondsExit Delay 2: seconds Entry Delay 2: seconds