ADDER AdderLink Infinity 2112T User Manual

Also see for AdderLink Infinity 2112T: Quick start guide User guide

Contents

ADDER AdderLink Infinity 2112T User Manual Manual pdf 12 page image

11 INsTAllATIoNCONFIGURATIONOPERATIONFURTHERINFORMATIONINDEXAUX portThe AUX port is an RS232 serial port thatallows extension of RS232 signals up to abaud rate of 115200. The port has softwareflow control, but no hardware flow control.AUXSerial (null-modem) linkfrom your computerTo connect the AUX port1 Ensure that power is removed from the ALIF unit.2 Connect a suitable serial ‘null-modem’ cable (see Appendix M for pin-out) between avacant serial port on your computer and the AUX port on the right hand side of theALIF dual rear panel.Power inEach ALIF dual unit is supplied with a poweradapter and country-specific power cord.When all other connections have beenmade, connect and switch on the poweradapter unit.INDOORUSE ONLY OPT15V2.5A12 Connect the IEC connector of the supplied country-specific power cord to the socketof the power adapter.3 Connect the power cord to a nearby main supply socket.Note: Both the unit and its power supply generate heat when in operation and will becomewarm to the touch. Do not enclose them or place them in locations where air cannot circulateto cool the equipment. Do not operate the equipment in ambient temperatures exceeding 40o C.Do not place the products in contact with equipment whose surface temperature exceeds 40o C.Power cordfrom adapterNote: Ensure thatOptions switches 1and 2 are both in the‘OFF’ (up) positionto enable normaloperation of the unit.See Options switchesfor details.To apply power in1 Attach the output lead from the power adapter to the 5V socket on the rear panel ofthe unit.