ADC CUDA 3 Administration Manual

Also see for Cuda 12000: Installation guide

Contents

ADC CUDA 3 Administration Manual Manual pdf 148 page image

ADC Telecommunications, Inc.146 C HAPTER 7: P ACKET O VER SONET A DMINISTRATIONEnabling NCPIP Control Protocol (IPCP) is the Network Control Protocol (NCP) used toconfigure, enable, and disable IP protocol access on both ends of a SONETpoint-to-point circuit. In order for IP packets to be transmitted over thepoint-to-point link, IPCP must reach the open state. This enables IPcommunication between the two circuit endpoints.By default, the Cuda 12000 is configured to provide its IP address duringIPCP negotiations. But when negotiating with a Juniper Networks system,providing the IP address during IPCP negotiation prevents a successfulconnection.When the interface must connect with a Juniper Networks system, you candisable reporting of an IP address during IPCP negotiation.To enable or disable reporting of the IP address during negotiation, performthe following task within interface pos mode:Task Command1. Enable the reporting of the IPaddress during IPCPnegotiation.ppp ipcp-report-address2. Disable the reporting of the IPaddress during IPCPnegotiation.no ppp ipcp-report-address