ADC Telecommunications, Inc.44 C HAPTER 2: ABOUT THE C OMMAND LINE INTERFACERoot ModeRoot is the top-level mode in the CLI administration console; all other modesrun within this mode. From within root mode you can access second-levelcommand modes, such as slot configuration mode. To enter root mode fromwithin any configuration mode, type root.Table 2-2 lists available root commands as they appear when you type helpat the command prompt. Global commands are not listed and can be foundin Table 2-1 on page 42. Note that the help command output displays manycommands in their abbreviated form.Table 2-2 Root Mode CommandsCommand Descriptionaaa Configures TACACS+ and RADIUS networkauthentication.access-list Creates an access list, which consists of IP filteringrules.access-profile Creates an access profile for a user.account Creates user accounts.alarm-throttle Configures alarm delivery and threshold parameters.aux-device Configures hardware alarm and clocking parameters.bridge-group Creates a bridge group.bridge-timeout Configures timers for bridge group broadcast flows.ccdown Shuts down the control module.chassis Configures multi-chassis support parameters.chassis-config Configures local chassis parameters.chassis-fault Configures chassis alarms.cm-filter Creates a cable modem filter.db-check Validates provisioning database information.db-connect Configures access to the provisioning database.event-config Configures event reporting, throttling, and syslogparameters.event-log Empties the event log.http-server Starts and stops the Web server.lookup Controls the Jini lookup service on the chassis.
