Installation79Installing the mechanical accessories into the cabinetFor frame G1, see the assembly drawing on page 81. For frame G2, see theassembly drawing on page 82. Install the mechanical accessories into the cabinet asfollows:1. If you use a bottom plate, make the bottom plate according to the dimensiondrawing on page 150) and install the bottom plate on the bottom of the cabinet.Note: If the thickness of the bottom plate is not 2.5 mm (0.1 in.), adjust thedimensions accordingly.2. If you use Rittal support rails (TS 4396.500), install three support rails on thebottom of the cabinet, see also the dimension drawing on page 145 (frame G1) orpage 149 (frame G2).3. Install the pedestal guide onto the bottom plate (or support rails).4. Install the Rittal punched sections TS 8612.610 (5 pcs) and TS8612.140 (3 pcs).5. Install the air baffles (see page 83).6. Install the top guide plate.7. Install the output cabling panel. Note: After you have installed the output cablingpanel, you can remove the support rail that is under the panel if there is notenough space for cables.8. Install the side guides to the output cabling panel (2 screws for each side guide).
