Installation checklist109Installation checklistWhat this chapter containsThis chapter contains a list for checking the mechanical and electrical installation ofthe drive.Installation checklistGo through the checklist below together with another person.WARNING! Follow the safety instructions, page 14. Ignoring the instructions cancause physical injury or death, or damage to the equipmentCheck that …Cabinet constructionThe drive module is fastened properly to the cabinet. (See chapters Planning the cabinet installation andInstallation.)Mechanical joints are tightened and not broken.Parts are clean and painted surfaces not scratched.The cabinet frame and parts which are in metal to metal contact with the frame (for example seams, componentfixing points on assembly plates, back of control unit mounting plate) are not finished with non-conducting paint ormaterial.Degree of protection (IPxx)Drive option modules and other componentsType and number of option modules and other equipment is correct. Option modules and other equipment are notdamaged.Option modules and terminals are labelled correctly.The placement of option modules and other equipment inside the cabinet and on the cabinet door is correct.The mounting of option modules and other equipment is correct.Internal cabling of the cabinet assemblyMain circuit:• AC supply input cabling is ok.• AC output cabling is ok.• Supply for brake resistor (if used) is ok.Cable types, cross-sections, colours and optional markings are correct.Cabling is not susceptible to interference. Check the twisting of cables and cable routes.
