A-Tach Mounts ST-1 Instructions Manual

A-Tach # 50148Designed for: Jeep Wrangler JK 2006 – 2010ST-1 A-TachMobile Device MountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle due to the installationand/or use of the product. The product has beentested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible for the use of the product andto determine if you have the skill to attach theproduct without causing damage to your vehicle orthe product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.(1) Clean the area where the mount will attach. Themount will attach into the two seams illustratedwith the arrows in photo 1 and 2.(2) You will need to use the seam tool to open thisfront seam up a little for the mount to insert into.(3) Press the seam tool into the seam between thedash top and the frame around the display/radio toopen the seam. See photo.(4) Remove the covering from the tape on themount. Press the thin lower edge of the mount allthe way into the seam next to the seam tool untilthe tape touches the dash top.

/ 2

Related manuals for A-Tach Mounts 50148