3Dlabs Wildcat4 User Manual

Software ConfigurationNOTE: If setup is not able to find 3ds max in the system registry, it will not install thedriver and will exit. Consult your 3ds max application's documentation to verifythat the application is installed correctly. The driver setup program will only installfor a registered application.Verify the Default Video Display DriverVerifying under Windows 20001. From the Windows Start menu, go to Settings/Control Panel/Device Manager.2. Under Display Adapters, verify that two Wildcat devices are listed. This indicates that theappropriate driver is installed.NOTE: If only one Wildcat4 device is listed, you may not have completed installation.Refer to “Installing the Driver Software” for instructions.3. Click Cancel to close the Display Properties dialog box.Verifying under Windows XP1. From the Windows Start menu, go to Control Panel/Performance and Maintenance/ SystemHardware/ Device Manager.2. Under Display Adapters, verify that two Wildcat devices are listed. This indicates that theappropriate driver is installed.NOTE: If only one Wildcat4 7210 device device is listed, you may not have completedinstallation. Refer to “Installing the Driver Software” for instructions.3. Click Cancel to close the Display Properties dialog box.Verify the System Startup VersionVerifying under Windows 20001. From the operating system Start menu, go to Settings/Control Panel/System/Advanced.2. Click Startup and Recovery.3. On the Startup and Recovery dialog box, verify that "Microsoft Windows 2000Professional" is the listed as the Default operating system. It is IMPORTANT that youroperating system matches the driver you installed. Click OK.4. Click OK again to close the System Properties dialog box.3Dlabs Graphics Accelerator Card User's Guide14