3Com Wireless LAN Switch WX1200 Command Reference Manual

Also see for 3CRWX120695A: User guide User guide Configuration guide Installation and Basic Configuration Guide Command reference

Contents

3Com Wireless LAN Switch WX1200 Command Reference Manual Manual pdf 585 page image

set boot backup-configuration 585Access — Enabled.History —Introduced in MSS Version 3.0.Usage — If you do not specify a filename, MSS replaces theconfiguration file loaded during the most recent reboot. To display thefilename of the configuration file MSS loaded during the most recentreboot, use the display boot command.The command completely replaces the specified configuration file withthe running configuration.Examples — The following command saves the running configuration tothe configuration file loaded during the most recent reboot. In thisexample, the filename used during the most recent reboot isconfiguration.WX4400# save configConfiguration saved to configuration.The following command saves the running configuration to a file namedtestconfig1:WX4400# save config testconfig1Configuration saved to testconfig1.See Also display boot on page 573 display config on page 574 load config on page 578set bootbackup-configurationSpecifies the name of a backup configuration file to be used in the eventthat MSS cannot read the WX switch’s configuration file at boot time.Syntax — set boot backup-configuration filename filename —Name of the file to use as a backup configuration file ifMSS cannot read the WX switch’s configuration file.Defaults — By default, there is no backup configuration file.Access — Enabled.