578 CHAPTER 20: F ILE MANAGEMENT COMMANDSSee Also display boot on page 573load config Loads configuration commands from a file and replaces the WX switch’srunning configuration with the commands in the loaded file.CAUTION: This command completely removes the running configurationand replaces it with the configuration contained in the file. 3Comrecommends that you save a copy of the current running configuration toa backup configuration file before loading a new configuration.Syntax — load config [url] url — Filename. Specify between 1 and 128 alphanumeric characters,with no spaces.If the file is in a subdirectory, specify the subdirectory name, followedby a forward slash, in front of the filename. For example:backup_configs/config_c.Defaults — The default file location is nonvolatile storage.The current version supports loading a configuration file only from theswitch’s nonvolatile storage. You cannot load a configuration file directlyfrom a TFTP server.Hardware Version information for the WX switch’s motherboard andPower over Ethernet (PoE) board.Serial number Serial number of the WX switch.Flash Flash memory version.Kernel Kernel version.BootLoader Boot code version.Port/DAP Port number connected to a MAP access point.AP Model MAP model number.Serial # MAP serial number.Versions MAP hardware, firmware, and software versions.Table 106 Output for display version (continued)Field Description
