Logging in through the Console Port 35Note that if you configure to authenticate the users in the scheme mode, thecommand level available to users logging into a switch depends on the commandlevel specified in the service-type terminal [ level level ] command.Configure theConsole portSet thebaud ratespeed speed-value OptionalThe default baud rate of theAUX port (also the Consoleport) is 9,600 bps.Set thecheckmodeparity { even | none | odd}OptionalBy default, the check modeof a Console port is set tonone, that is, no check bit.Set thestop bitsstopbits { 1 | 1.5 | 2 } OptionalThe default stop bits of aConsole port is 1.Set thedata bitsdatabits { 7 | 8 } OptionalThe default data bits of aConsole port is 8.Configure the command levelavailable to users logging into theuser interfaceuser privilege level level OptionalBy default, commands oflevel 3 are available to userslogging into the AUX userinterface.Make terminal services availableto the user interfaceshell OptionalBy default, terminal servicesare available in all userinterfaces.Set the maximum number of linesthe screen can containscreen-lengthscreen-lengthOptionalBy default, the screen cancontain up to 24 lines.You can use thescreen-length 0 commandto disable the function todisplay information in pages.Set history command buffer size history-commandmax-size valueOptionalThe default history commandbuffer size is 10. That is, ahistory command buffer canstore up to 10 commands bydefault.Set the timeout time for the userinterfaceidle-timeout minutes [seconds ]OptionalThe default timeout time of auser interface is 10 minutes.With the timeout time being10 minutes, the connectionto a user interface isterminated if no operation isperformed in the userinterface within 10 minutes.You can use theidle-timeout 0 command todisable the timeout function.Table 16 Console port login configuration with the authentication mode being schemeOperation Command Description
