kim lighting Bell KLV50 Installation Manual

kim lighting Bell KLV50 Installation Manual Manual pdf 1 page image

Bell™ Wall Mount - KLV50/52/55/57 InstallationP.O. Box 60080 • 16555 East Gale Ave.City of Industry, California 91716-0080626/968-5666 • FAX 626/330-3861INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONSIMPORTANT SAFETY INSTRUCTIONS!WARNING - To reduce the risk of FIRE OR INJURY TO PERSONS: Do not overdrive the fixtures with greaterthan 12 volts or fixture over-heating and short lamp life will occur. Do not overload the transformer byinstalling (or relamping) higher wattage lamps than planned. Note: Total wattage of all lamps connected to onetransformer must not exceed the capacity of that transformer. Do not install luminaire within 10 feet (3.04m) of apool, spa or fountain.SAFETY WARNING: When relamping be sure electrical supply is OFF. Lighted lamp is HOT! Low voltagefixtures can become very hot depending on the lamp wattage used. Glass lenses and metal areas above &around the lamp can become hot enough to blister hands. Use discretion when touching fixture and be sure toallow fixture to cool before relamping. Particular care should be taken not to locate fixture where small childrencan reach them if higher wattages are used. NOT INTENDED FOR INDOOR USE.NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten the lamp life.All electrical work should be done by a qualified electrician.KEEP THIS SHEET FOR FUTURE REFERENCE.Tools Required: Flat Blade Screwdriver 3/32” Allen WrenchInstallation Instructions: Make certain electrical supply is OFF before starting fixture installation.1. Attach mounting plate to J-box with screws provided. Apply clear silicone toinside of wall canopy to ensure water tightness.2. Connect fixture cable to mainsystem cable.3. Attach wall canopy and fixture tomounting plate. Secure with two(2) flat head screws provided.KLV50 / KLV52KLV55 / KLV574. Remove lens frame and lens.(Step 4 not required on L.E.D.version, for L.E.D. fixture skip tostep 6).Revision 7/16/10 EC 100715008 Status 7 Part No. 95620!!!5. Install lamp of type & wattage as shown onfixture label and chart. Reinstall lens andlens frame. (Step 5 not required on L.E.D.version, for L.E.D. fixture skip to step 6).

/ 2

Related manuals for kim lighting Bell KLV50