57CAUTION！If you click Delete after selecting a camera, the system automatically stops the corresponding storage planof the channel and deletes the corresponding storage plan and recorded data. Therefore, exercise cautionwith the deletion operation.Alarm‐Triggered RecordingAlarm‐triggered recording is used to trigger camera storage. The storage is triggered by an alarm.1. Configure camera storage resources according to the power‐on wizard, and set the after‐alarmrecording time according to actual requirements. The after‐alarm recording time is the duration ofalarm‐triggered storage.2. Configure alarm‐triggered storage. For details, refer to 2 Configuring the Triggered Action.Checking the Channel Recording StateSteps Screenshot1. Right‐click anywhere in the previewinterface, and then choose Menu >Storage > Information.The storage information interface is displayed.2. Check the recording state of eachcamera in the storage information list.For details about state definitions,see Table 5‐1.NOTE！After configuring the storage plan of a channelaccording to the power‐on wizard, you can alsostart or stop the storage plan in theconfiguration interface.Table 5‐1 Definitions of Recording StatesParameter DescriptionResourcez Unknown: No storage resource is allocated.z Normal: Storage resources have been allocated.z Inaccessible: Storage resources are abnormal.Schedule Storez Unknown: No storage resource is allocated.z Planned: Storage is performed according to the corresponding storage plan.z Unplanned: Storage is performed outside the storage plan, or problems such asnetwork exceptions or default faults have occurred.
