Menu
Zeta NPAD 2 User Manual, Maintenance Manual & Log Book
Also see for Premier AD: Installation manualUser manual, maintenance guide & log bookInstallation manual
                        | |
Contents
| 
PREMIER AD USER MANUAL, MAINTENANCE GUIDE & LOG BOOKApproved Document No: GLT.MAN-106A PAGE 3Issue: 2.00 Authorised: GH Date: 16/07/20071. FIRE ALARM CONTROL PANEL SAFETY ISSUESThere is no need to open this fire alarm during normal operation. Any work carried out on this system must beperformed by a competent person who is familiar with this type of system.This equipment will operate safely provided it has been installed correctly in compliance with the InstallationManual.It is recommended that the system is serviced frequently. It is customary to arrange a regular maintenancecontract with a competent organisation. (Ask the installation company for recommendations). The systemneeds a thorough maintenance check annually at the very minimum.If any part of this Fire Alarm Control Panel becomes damaged, contact the company responsible for systemmaintenance to arrange repair / replacement.C E European Union Directives Conformance StatementThis product has been manufactured in conformance with the requirements of allapplicable EU Council Directives. The Declaration of Conformance for thisproduct is located at the following Address: GLT Exports Ltd, 72-78 Morfa Road,Hafod, Swansea, SA1 2EN, United Kingdom2. THE PURPOSE OF A FIRE ALARM SYSTEMA Fire Alarm System is used to provide an early warning of a fire, so that the property can be evacuated andthe fire extinguished if it can be safely tackled, or the local fire brigade called, according to the companyevacuation procedure.Alarms can come from Smoke or Heat Detectors, or manually by a person operating a Manual Call Point.Splits the building into Zones, each covering a different area of the building. This will indicate which area of thesystem is giving the alarm (or fault).During an alarm, the panel will start its sounders, and indicate which zone has the fire. It will also activate itsauxiliary relay.Fault MonitoringThe panel checks all circuits for line integrity. If a part of the system has a problem, which may affect itsoperation, a fault warning must be given by the fire alarm panel (LED & buzzer indication). The fault relay willalso activate.DisablementsAn engineer may be required to work on part of a system, while the system is still active (eg extending adetection zone). During such circumstances, it would be advisable to disable that zone, so that it will not givefalse alarms. Similarly you may wish to disable a zone that has a fault that has not been fixed, or a zonecovering an area with a temporary unusual environment, such as an area which is dusty because ofconstruction work etc.Power Supply Equipment- General Description.The NPAD FACP has an integral linear power supply capable of supplying 1.5 amps in total. It contains a currentlimited output for charging sealed lead acid batteries (7 Ah maximum). The PSE is monitored for main supplyfailure, the battery not taking a charge and low battery voltage. If the battery voltage drops below approximately20VDC (a fault condition), the battery charging current will be turned off , thus stopping charging. This PSE isonly capable of supplying power to the CIE, and is not designed for any other use. |
Related manuals for Zeta Premier AD
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved