Zanussi ZWT816PCWA User Manual

Ø 40 mmTo a stand pipe with vent-holeDirectly into a drain pipe at a height of not less than60 cm (23.6”) and not more than 100 cm (39.3”).The end of the drain hose must always be ventilated ,i.e. the inner diameter of the drain pipe (min. 40 mm -min. 1.6”) must be larger than the external diameterof the drain hose.max.600 mmTo a sink spigotPut the drain hose in the spigot and tighten it withthe supplied cable tie L.Make sure that the drain hose makes a loop to pre-vent particles going into the appliance from the sink.LTo a wall-pipeDirectly to a built-in drain pipe in the room wall andtighten it with the supplied cable tie L.You can extend the drain hose to maximum 400 cm. Contact the service centre for the otherdrain hose and the extension.BUILDING IN600 mmmin.820 mmmin.560 mm16-22 mmmin.This appliance has been designed to be built into thekitchen furniture. The recess should have the dimen-sions shown in this picture.For recess with a height different than820 mm, it is possible to buy the appro-priate kit on the website.10