Z Corporation 406 User Manual

Also see for Z 406: User manual

Contents

Z Corporation 406 User Manual Manual pdf 92 page image

Z Corporation Z406 System User Manual92 Z Corporation Service (781)852-5050/(877)88-ZCORP9 CHANGING MATERIAL SYSTEMIF USING ZCAST POWDERBefore using ZCast powder, a hardware upgrade (Z406 ZCast Kit, part number 06215) isneeded to prevent damage to your Printer.The hardware change includes newsnowplows. A build plate is also included tohelp remove parts from the build envelope.Please ensure that these hardwarechanges have been made beforeproceeding.For information on how to design a ZCastmold, read the ZCast Design Guide whichcan be found in the appendix of thismanual or in the Applications section of theUser Group Website at www.zcorp-users.com.1. Remove all powder from the feed andbuild envelopes. Place powder in asealed container to preventabsorption of moisture into thepowder.2. To prevent material contaminationvacuum off any remaining powderfrom the feed and build plates, andthe top deck.Snowplows