YASKAWA JEPMC-MP2300-Y Series User Manual

Contents

YASKAWA JEPMC-MP2300-Y Series User Manual Manual pdf 531 page image

11.2 Precautions When Setting or Changing User Definition Files and Scan Times11-7[ b ] SERVOPACK Parameters (2) The above set values are written to the SERVOPACK’s RAM.11.2 Precautions When Setting or Changing User Definition Files andScan TimesThis section describes precautions for setting or changing user definition files and for setting the scantimes.11.2.1 Setting or Changing User Definition FilesUser definition files must be saved to flash memory (Save & Save to Flash).Use the MPE720 to set or change a user definition file. Be sure to save the results to flash memory. Ifdata is not saved to flash memory, the settings and changes will be lost when the power supply to theMP2300 is turned OFF and ON.11.2.2 Setting or Changing Module Configuration Definition FilesObserve the following precautions when setting or changing module configuration definition files.• Always check to make sure that the mounted Module is the one that is defined.• Be sure to save any new settings or changes to flash memory.• After the settings or changes have been completed, turn the power supply to the MP2300OFF and ON.MP2300 SERVOPACKSERVOPACK Parameters SGD-N,SGDB-NSGDH +NS100SGDH +NS115 SGDSName SettingExcessive Position ErrorArea 65535 → Cn-001E －Overflow Level 32767 → － Pn505 －Excessive Position ErrorAlarm Detection Level 2 30 -1 → － Pn520Excessive Position ErrorWarning Detection Level 100 → － Pn51EUser Definition Files