Menu
Xycom 9465 PC/AT Manual
                                                                                       | |
Contents
| 
Chapter 3 – Installation3-214. Reconfigure jumpers J1-J5. Position A = COM2. Position B = PS/2 AUX. (Note: alljumpers must be in the A or B position).5. Reinstall the touchscreen controller card.6. Reboot the computer.7. Using the touchscreen manual, do the following:• Load the touchscreen drivers• Reconfigure the touchscreen driver for COM2• Recalibrate the touchscreen8. Replace the lid.NoteIf you ordered Windows 95 or NT on your system, the COM2 port is notavailable.Using a Pointing Device with a TouchscreenIn the touchscreen setup program you must specify if you are using a pointing device withtouchscreen. Refer to the touchscreen manual to configure the system for a pointing device.The pointing device driver is responsible for displaying the cursor. In the touchscreensetup program, Support for Another Pointing Device, select the following:If you are Select Resultusing another pointing devicewith the touchscreenYes The pointing device driver controls thecursor displaynot using another pointing device No The Setup program loads a cursor dis-play driver (MTSMOUSE.DRV) in addi-tion to the Windows touchscreen driverSpecifying the PortTo reconfigure the touchscreen driver for COM2 see the section in the touchscreen man-ual that explains Settings, Commands, and System Files.Calibrating the TouchscreenTo recalibrate the touchscreen, refer to the calibration and diagnostic utility sections inthe touchscreen manual.Video ExpansionThis section deals with the hardware expansion capability of the video controller chip inDOS applications.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com |
Related manuals for Xycom 9465 PC/AT
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved