Chapter Three - Installation213535T Front PanelIR PORTPOWER DISK COM INPUTT OU CHS CR E E N(OP T IONAL )I R P OR T P OW E R DI S K COM I NP U TFeature DescriptionDisplay The 3535T has a 15-inch (1024 x 768) XGA flat panel display.Diagnostics LED The 3535T features four status LEDs on the front panel, whichyou can use to monitor system operation.Power There is power to the 3535.Disk The computer module is accessing the disk drive.COM There is communication activity on one of thecomputer module’s serial ports, includingcommunication between the computer module and thetouchscreen (if on COM2) or a serial device.Input The unit has a touchscreen and the LED gets brighterwhen touch input is detected.During power-up, firmware on the processor board checks thehardware configuration against the configuration stored in theCMOS memory.IR (Infrared) The IR port transceiver is located behind this window. The3535 IR port is IrDA, and ASK-IR compliant. You can connectthe 3535 to any IrDA compatible device, if you load specialsoftware (not included). The infrared (IR) link operates at adistance of 0 to 1 meter and is capable of 115 Kbaud transferrates. Enable the interface through the BIOS setup menus.Note: When the IR port is chosen, COM2 is not available.Correspondingly, if COM2 is in use by the touchscreen the IR is notoperational.
