12 MaintenanceXerox WorkCentre 4260 User Guide 201If the feature is enabled, a message will appear on the display screen advising youto replace the Print Cartridge. If you want to replace the Print Cartridge now, openthe front door. The instructions on the screen will tell you how to fit a new cartridge.If you do not want to replace the Print Cartridge now you can select the Abortbutton. The machine will continue to operate but will NOT make copies or prints.1. Open the cover on the right side of the machine. This will reveal the latch usedto open the front cover. Open the front cover.2. Remove the Print Cartridge.The instructions that are packed with thenew Print Cartridge will tell you how todispose of the used Print Cartridge.WARNING: Only install the correctXerox Print Cartridge in the machine.3. Before unpacking the new PrintCartridge, shake well to distributethe toner. Remove from packaging.4. To fit the new Print Cartridge, make sure the toner is facing the correct way up5. Insert the Print Cartridge.6. Close the front cover.7. Select the Confirm button on the machine display.L If after fitting a newPrint Cartridge the frontdoor will not close, checkthat the Print Cartridge ispositioned and latchedcorrectly.If you have replaced the Print Cartridge as a result of a “Replace the PrintCartridge” message on the machine display, the machine will assume that youhave fitted a new cartridge and reset the toner usage counters and messages. If,however, you have fitted a new Print Cartridge without being instructed to do soby the machine display, the toner usage counters will need to be reset manually.This is done in the Access tools mode using the Supplies Management - PrintCartridge Re-order Notification feature.Staple CartridgeThis procedure shows you how to remove a used Staple Cartridge and replace itwith a new Staple Cartridge.Front cover latchPrint Cartridge
