quick use guide 13EnglishInstall Print DriversThis procedure describes how to install Print Drivers using the Print Driver CD.The Print Drivers are on the Print Driver CD that was delivered with your Phaser3635MFP.You can use the CentreWare Print and Fax Drivers CD to install multiplecomponents such as printer drivers, scan drivers, user documentation and PPDs(PostScript ® Printer Description) at the same time. To use the installer, load theCentreWare Print and Fax Drivers CD-ROM delivered with your Phaser3635MFP.1 At the client workstation insert the Driver CD into the CD drive.2 If the CD does not start automatically, go to the Start menu, click Run andbrowse to the CD drive. Click Setup and click OK. Click OK to start theinstallation procedure.3 Select the language for the installation and click Continue. The driver screen isdisplayed.NOTE: The selections are:Install Print and Scan Drivers - Installs both the print drivers and the scandrivers.Install Print Driver - Installs just the print drivers.Install Scan Driver - Installs just the scan drivers.To install Print Drivers use the instructions below. To install Scan Drivers, clickInstall Print and Scan Drivers.4 Click Install Drivers.5 Click Install Print Drivers.NOTE: The PCL6 Driver is installed by default.6 To install the PCL 5 or Adobe® PostScript® Print Drivers, click Option andcheck the boxes for the drivers required.7 Enter the Printer’s IP address, DNS name or UNC path for the device.8 Click Install.9 Follow the on screen messages to complete the installation.10 When the Print Driver is successfully installed, either send a test print from theprint driver or submit a job to the Phaser 3635MFP.11 If the printing operation is successful, continue on to the next setup procedure inthis document. If the print operation failed, refer to Troubleshooting on page 33.For a full explanation refer to the System Administration CD that accompaniedyour Phaser 3635MFP.