I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n sA p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s v C-55XeroxNetworkInterface Card(XNIC)This section contains two sets of instructions:• “Installing the XNIC” (page C-56)• “Removing the XNIC” (page C-60)These instructions apply to Ethernet (XNIC-E’NET), TokenRing (XNIC-T’RING) and LocalTalk (XNIC-L’TALK).CautionThe XNIC and controller board are sensitive to staticelectricity. Before installing the XNIC, discharge staticelectricity from your body by touching something metal, suchas the metal back plate on any device plugged into agrounded power source. If you walk around before finishingthe installation, again discharge any static electricity.Never remove the printer controller board while the printer isplugged in.NoteThe printer is capable of supporting two XNICs; however, donot install two of the same XNICs in the printer.hapterc.frm Page 55 Friday, July 11, 1997 9:25 PM